What happens when the call is “Acknowledged” by pressing and holding the “#” key?.The sequence of the message is as follows: A voice message will advise the type of alarm condition and instruct the person answering to enter a response code by pressing and holding the “#” key to “Acknowledge” the alarm, or pressing the “*” key followed by the “0” key to “Disable” the monitoring system.What to do when the monitoring system calls someone at a programmed telephone number.How the monitoring system works when it detects an alarm condition.Programming the Outgoing “Call-To” Telephone Numbers.Automatic Phone-Out Home Monitoring Systems.This monitoring system is an outgoing telephone device only and will not respond to any incoming telephone calls. The installation of these alarms requires that the monitoring system be tested after installation to insure that the monitoring system is compatible with both the outgoing telephone line and the telephone(s) that will be called. Read and thoroughly understand the instructions and warranty prior to Water Sensor can be connected to up to 100 feet of phone cord to reach potential hazard area. Operates in an ambient temperature range of 32 Red LOW BATTERY indicator light on control panel Visual indicator and audible signal when an alarm condition is detected ON/OFF switch to disable the monitoring system when monitoring is not desired and to reset the monitoring system when “Disabled”. Monitors the outgoing telephone line to establish a dial tone before making an alarm call-out.Ĭan select whether or not to monitor temperature.Ĭan be set for either a 5 minute or 30 minute call out delay after an alarm condition is detected Works on either rotary/pulse or tone telephone lines Will call up to three programmed telephone numbers when an alarm condition occurs The monitoring system control panel must be located where is has access to an active Touch Tone™ or rotary/pulse telephone line and a 120-Volt electrical outlet.Ĭlear voice message that specifies alarm type (temperature, power outage or flood) on the outgoing call WHEN THE MONITORING SYSTEM HAS BEEN DISABLED, IT MUST BE RESET AT THE CONTROL PANEL BEFORE THE MONITORING AND CALLING FUNTIONS WILL RESUME. “Disable” the monitoring system and halt all monitoring and calling features of this monitoring system. One hour intervals beginning with the first telephone call and continuing until the alarm condition no longer exists, or “Acknowledge” the call and allow the monitoring system to continue to inform them of the alarm condition at.The person answering the call from the alarms can choose to either:ĭo nothing and allow the monitoring system to call every 15 minutes while alarm condition exists. The presence of water at the location of the optional water sensor probe (when plugged into the control.The water sensor can be placed up to 100 feet from the control panel using additional telephone line.įor each of the following three potentially damaging situations, this monitoring system will automatically dial up to three user-programmed telephone numbers and advise the person answering that one or more of these conditions have been detected:Ī power failure in the branch circuit that the control panel is plugged into An additional water sensor is housed in a separate plug-in accessory, which is included with Model Number THP201. Sensors for power outage and temperature, featured in Model Number THP202, are housed in the main control panel. They are designed to automatically call up to three telephone numbers-such as your cell phone, your cabin phone, your primary residence phone, or a neighbor’s phone- when an alarm condition occurs. These monitoring systems are intended to monitor homes, cabins, and other premises for power outage, low temperature conditions and the presence of water. Power Outage, Freeze and Flood Alarm Model Number: THP201 Power Outage and Freeze Alarm Model Number: THP202 Automatic Phone-Out Home Monitoring Systems
0 Comments
Leave a Reply. |